Description
The AMT 316F-99 is a 5 HP Cast Iron pumps dredging pump 2" npt ball bearing. Delivers up to 173 GPM. AMT Engine Driven Dredging Pump is designed for pumping sea water and fresh water containing up to 25% sand, debris and other abrasive particles. This unit can be used for other marine applications including dredging, pile driving, pier maintenance,
Engine-Driven — Operates Without Utility Power
Engine-driven design provides pumping capacity at remote construction sites, emergency dewatering locations, and any application where utility power is unavailable or unreliable. Honda and Robin/Subaru engines provide proven reliability.
Trash Pump Design — Handles Large Solids
Large volute clearances and semi-open impeller pass rocks, sticks, leaves, and semi-solids that would destroy a standard centrifugal pump. Designed for construction site dewatering where the pumped fluid contains significant debris.
Self-Priming — Fast Deployment
Self-priming capability allows rapid deployment without suction line preparation. Fill the priming chamber once and the pump primes itself — critical for emergency dewatering where every minute of setup time has operational cost.
Cast Iron Construction — Field Durability
Cast iron volute and impeller withstand the abuse of construction site operation. Designed to be serviceable in the field — standard replacement impellers, mechanical seals, and wear rings are stocked by AMT distributors.
High Volume Capability
Engine-driven trash pumps deliver high flow rates at low head — the correct performance curve for fast-fill, fast-drain, and high-volume dewatering applications where moving large volumes quickly is the priority.
Portable Design
Compact, portable design with lifting handle for single-person transport. Engine and pump are close-coupled on a single base — no alignment required after transport or repositioning on the job site.
| Model Number | 316F-99 |
| Series | 2˝ Engine Driven Dredging Pumps |
| Category | Engine Driven and Diaphragm Pumps |
| Horsepower | 5 HP |
| Casing Material | Cast Iron |
| List Price | $1,562.00 |
| Max Flow Rate | 173 GPM |
| Max Head | 101 Ft. |
| Max Temperature | 180° F |
| Max Solids Handling | 1/2 |
| Max Flow Rate | 173 GPM |
| Max Head | 101 Ft. |
| Max Fluid Temperature | 180° F |
| Max Solids Handling | 1/2 |
| Model | HP | Type | Frame | Voltage | Phase | Casing | Seal | Weight | List Price |
|---|---|---|---|---|---|---|---|---|---|
| 316F-95 | 5 HP | 2,221.00 | |||||||
| 316F-99 | 5 HP | Cast Iron | 1,562.00 |
★ Highlighted = this product (316F-99). All models share the same casing and spare parts. QSP = ships within 24 hours.
| Fluid compatibility | For use with non-flammable, non-abrasive liquids compatible with pump component materials. Verify chemical compatibility before use. |
| Seal compatibility | Always verify seal material compatibility with your specific fluid and chemical conditions. |
| Electrical | Requires a properly sized, grounded branch circuit. Do not use an extension cord. Protect motor with a properly sized thermal overload relay. |
| Temperature limit | Maximum fluid temperature 180° F. Exceeding this limit will damage seals and motor insulation. |