Description
The AMT 2S7XZR is a 7 HP aluminum trash pump 2" discharge. pedestal drive pumps are also available for direct or drive belt connection. SPECIFICATIONS Position strainer well below liquid surface and on a bed of rocks or other suitable surface. If possible tie strainer up so it is suspended off pit bottom. St
Engine-Driven — Operates Without Utility Power
Engine-driven design provides pumping capacity at remote construction sites, emergency dewatering locations, and any application where utility power is unavailable or unreliable. Honda and Robin/Subaru engines provide proven reliability.
Trash Pump Design — Handles Large Solids
Large volute clearances and semi-open impeller pass rocks, sticks, leaves, and semi-solids that would destroy a standard centrifugal pump. Designed for construction site dewatering where the pumped fluid contains significant debris.
Self-Priming — Fast Deployment
Self-priming capability allows rapid deployment without suction line preparation. Fill the priming chamber once and the pump primes itself — critical for emergency dewatering where every minute of setup time has operational cost.
Cast Iron Construction — Field Durability
Cast iron volute and impeller withstand the abuse of construction site operation. Designed to be serviceable in the field — standard replacement impellers, mechanical seals, and wear rings are stocked by AMT distributors.
High Volume Capability
Engine-driven trash pumps deliver high flow rates at low head — the correct performance curve for fast-fill, fast-drain, and high-volume dewatering applications where moving large volumes quickly is the priority.
Portable Design
Compact, portable design with lifting handle for single-person transport. Engine and pump are close-coupled on a single base — no alignment required after transport or repositioning on the job site.
| Model Number | 2S7XZR |
| Series | 2″-3″ IPT Trash Pumps |
| Category | Engine Driven and Diaphragm Pumps |
| Horsepower | 7 HP |
| List Price | $8,505.00 |
| Max Temperature | 180° F |
| Max Solids Handling | 1 |
| Max Fluid Temperature | 180° F |
| Max Solids Handling | 1 |
| Fluid compatibility | For use with non-flammable, non-abrasive liquids compatible with pump component materials. Verify chemical compatibility before use. |
| Seal compatibility | Always verify seal material compatibility with your specific fluid and chemical conditions. |
| Electrical | Requires a properly sized, grounded branch circuit. Do not use an extension cord. Protect motor with a properly sized thermal overload relay. |
| Temperature limit | Maximum fluid temperature 180° F. Exceeding this limit will damage seals and motor insulation. |
- Model
- 2S5XZR